• Always check the User Manual for guidance on the safe use of your RediKettle before you boil any water.



    CAUTION: Always ensure the RediKettle is on a flat surface and the power cable is positioned in the channel correctly.


    Remember that you will be working with hot water and steam, so always ensure that all the safety requirements are fully in place before you start boiling water.

    Also refer to the Important safety information Topics in this guide.

  • 1.

    If the RediKettle base needs resetting, ensure the RediKettle is empty and is positioned on the kettle base.

  • 2.

    Press down the 60 button and the power button at the same time for approximately 4 seconds until there is an audible ‘BEEP’ 3 times in succession.

  • 3.

    Remove your fingers from the buttons. After approximately 6 seconds there will be a further audible ‘BEEP’ 5 times in succession.

  • 4.

    Unplug the kettle base from the mains for 30 seconds.

  • 5.

    Plug the kettle base back into the mains.

    The RediKettle will beep once.

  • 6.

    The kettle base should now flash 0.